Builders working on their trial vnum do not need to learn this command, yet. Usage: buildwalk BuildWalk is an OLC utility that will allow a builder to enable a "buildwalking" mode. In this mode, walking in a direction that doesn't exist will find the next free room in the zone, create the room, and make a two-way exit between the room the builder was standing in, and the new room. This way a builder can create a framework of their zone by walking around. Buildwalking can be a little misleading. A builder can not walk n, e, s, w, and end up in the same room they started. Buildwalk is not spatially aware of other rooms. It will always create a new room if you walk in a direction without a current exit. It is often necessary to backtrack to prevent overlapping rooms. NOTE: Buildwalk does not autosave on exit. You must type SAVEALL. This way if you mess up and want the rooms deleted we can just reboot and wipe them. Be careful using buildwalk. If you mess up you will have a lot of rooms to delete. See also:: TOGGLE, SAVEALL, REDIT, OLC, RLIST, DIG